Introduction:

We al now, our workbench area is often not very large. Somethimes a little
spot somewehere in the house, or a table in the shed and if we are lucky we can
use a room in our house. That's one, the workbench, second problem is the spray/airbrush area.
Airbrushing inside you're house isn't good for you're health, you always have to work in a good
ventilated room. Beside that its take's a lot of space to create a place where you can leave you're
airbrushing stuff when you finished you're spraywork.
When you decide to airbrush in you're house or in a shed ore even take you're spraywork to modelclub, friend, etc...
there is a now a great solution for al the problems we can ran into. A portable spraybooth!

Features:

So, we will review here a portable spraybooth. The spraybooth can be fold and deploy, smart in size and light in weight.
It has a small power, with a big air flow and no need of ventilation pipe, it save also energy and protect the enviroment.
It's has also a high density net and filter almost al the paint and moisture. And there is no pollution.
An electric wire and plug are inside and can be draw out and can be shrink automaticly when you hit the press buttom.
You can also combine two single spray booths to use them as one, very handy for big kits or structures.
Offcourse it has a on/off switch and it will light on when the power is on. Low noise, about 45db.
And last but not least, it has a revolving turn plate. Very handy, so you don't have to handle you're work when you're are airbrushing.

Specification:

-Voltage, frequently and plug according to different country's

-Power: 25W

-Air flow: 3 m³/min

-Noise level: 45 db.

-Extend dimensions: 42x48x34cm

-Shrink dimensions: 42x15x25cm

-Net weight: 3,8 kg

Conclusion:

This spray booth is a very handy item for us as a modeller. Light in weight, low noise, small when retracted...and the main thing, a fresh and clean air in you're workarea!

When the spray booth is fold there is a handle on top of it and four rubber foots for a steady stand.

Open the small door where the power cord houses, it can be pull out to a lenght of 1,7 Meter.

After pulling the power cord, the small door can be closed. There is a small hole for the power cord so it will not affect the use
of to spray booths.

Before you shrink the spray booth to the portable modus, press the the power cord button. The power cord will retract
automatcally. Finally close the cord door.

When you take use of two spray booth for the use as one single, you have only dismantle the right side booth side of left set and left booth
side of righ set, then combine the two spray booths togheter.